Raspberry Pi 4 vs Odroid XU4 vs Odroid N2 – Which is best for Kodi or Plex?

With the early launch of the Raspberry Pi 4, there is a tremendous amount of hype about the single board computer, and pretty much every online store is sold out of stock.

The new model is a huge upgrade from the previous generation with a massive improvement across the board, including a much-improved CPU, more RAM, proper gigabit ethernet and USB 3.0. This makes the RPi4 an appealing prospect for many home networking projects such as a Plex media server, Kodi box, NAS, home automation and many more projects.

In recent years, for a home server and media projects, the RPi has lost a little bit of ground compared to the more powerful Odroid options. In particular, for Kodi builds the Odroid C2 and N2 is often recommended over the RPi due to its superior performance and 4K abilities.

So if you want to do a server or media based project is it worth waiting for the RPi 4 or will Odroid be a superior option?

Odroid XU4

I have included the Odroid XU4 on the list as it was close to the RPi pricing while offering impressive specs; however there are some key points to consider before going down this route.

For Kodi builds, there appears to be limited support with a long thread about the XU4 not supporting Kodi 18 though this RetroElec build should support it.

The XU4 also has active cooling and depending on how close it is to you it could be audible. It is possible to upgrade it to passive though.

Finally, I can’t see any GPIO headers listed on the spec sheet, so this isn’t a great choice for building things, but shouldn’t be an issue for Kodi and servers.


The Raspberry Pi 4 has the clear advantage with pricing, the most expensive model is $55, which is cheaper than the RRP of the XU4 and considerably less expensive than the $79 of the N2.

To make matters worse, for UK buyers, the price goes up to around £83 when you factor in shipping.


While I have not tested any of these devices yet, the N2 should be a clear winner by a significant margin. It has a quad-core Cortex A73 CPU clocked at 1.8Ghz combined with a dual-core A53

While it is hard to compare the GPU like for like, the N2 while no doubt have superior processing capabilities, though it only has one HDMI out.

Similarly, the storage performance is considerably higher for the N2 as it can use eMMC, though it is worth noting this also costs a lot more than microSD so the costs go up again.

In benchmarks, the N2 outperforms the XU4 considerably, which in turn should comfortably outperform the RPi4.


All three devices offer gigabit ethernet so they should all perform similarly. However, neither Odroid device has Wi-Fi, and you need to use a USB adaptor to achieve this.


In the end, it is not really a like for like comparison, the Odroid N2 is getting close to twice the price, but will offer significant performance advantages over the RPi 4. If budget is not a concern and you want the best Kodi experience then the Odroid N2 will be your best bet.

On the flip side, Raspberry Pi has never been about offering the best performance, its advantage over every other option has always been the vast community behind it developing and maintaining software as well as all the accessories you can buy for it allowing you to use it as the basis of hundreds of project ideas.

Price $35,$45,$55 $59/$49 $79
Chipset Broadcom BCM2711 Samsung Exynos5422 Amlogic S922X Processor (12nm)
CPU Quad core Cortex-A72 (ARM v8) 64-bit SoC @ 1.5GHz ARM Cortex-A15 Quad 2.0GHz/Cortex-A7 Quad 1.4GHz Quad-core Cortex-A73(1.8Ghz) and Dual-core Cortex-A53(1.9Ghz)
GPU VideoCore VI 3D up to 500 MHz. Mali-T628 MP6 Mali-G52 GPU with 6 x Execution Engines (846Mhz)
RAM 1,2,4 2Gbyte LPDDR3 DDR4 4GiB or 2GiB with 32-bit bus width
Storage Micro-SD card eMMC module socket : eMMC 5.0 Flash Storage (up to 64GByte)
MicroSD Card Slot (up to 128GByte)
1 x eMMC connector (8G, 16G, 32G, 64G and 128G are available)
1 x microSD slot (DS/HS modes up to UHS-I SDR104)
Ethernet Gigabit Ethernet 1 x GbE LAN ports (RJ45, supports 10/100/1000 Mbps) 1 x GbE LAN ports (RJ45, supports 10/100/1000 Mbps)
GPIO  40 pin GPIO header 25 x GPIO (Max)
Video Output 2 × micro-HDMI ports ( HDMI 1.4a with a Type-A connector 1 x HDMI 2.0 (up to [email protected] with HDR, CEC, EDID)
USB 2 USB 3.0 ports; 2 USB 2.0 ports. 2 USB 3.0 ports; 1 USB 2.0 ports. 4 x USB 3.0 Host ports (shares one single root hub)
1 x USB 2.0 OTG port for Host or Device mode. (No power input)


product image
Author Rating
Aggregate Rating
3.5 based on 8 votes
Brand Name
Product Name
Pi 4 Model B
GBP 35
Product Availability
Available in Stock

Maikel Du

I worked in many technical fields, but I always resort to blogging which has become an addiction to me
Back to top button

Adblock Detected

Our site is based on profit from Google ads, please cancel the ad blocker in order to support our work